The cameras
Click on "Add camera". This opens the window configuration of camera (except for the first camera). On this window select the "Source capture" panel then choose a camera and click "OK".
Repeat as many times as necessary until you have memorized all the cameras.
If the camera image is blurred click on button"Format" (see button 8 below) then select "RGB 24"."
If you click "Start the cameras" all saved cameras will start.
Camera track
1: Image of the camera. Click above to display the monitor.
2: Intrusion led.
3: Name of the camera. Click on it to change it.
4: Viewing the threshold of sensitivity.
5: Value of threshold of sensitivity.
6: Anti-interference filters.
7: Choice of the video source.
8: Choice of video format.
9: Close the camera track.
Renaming cameras:
Simply enter the new name instead of "camera 1,2,3 etc. (See 3) on each cameras track.
Reverse order of tracks:
With the mouse, move the tracks.
Display monitors:
Click on the image of the camera (See 1). This opens the monitor of the track.
The anti-interference filters: (See 6)
The camera image is not perfect because many interferences distorts the analysis.
To remedy this problem these pixels are discriminated as following:
-Anti-interference 1: The detected pixels which are isolated are ignored.
-Anti-interference 2: The pixels that are not detected on two consecutive images are ignored.
-Persistant intrusion: A zone that is detected triggers the alarm only if it persists on several images.