First use

   In the first use, Windows or your antivirus might ask you if you allow MultiCam and its auxiliary programs to communicate with the Internet. It is important to allow them if not it does not work properly.

To use the remote control and video surveillance, with a PC connected to a network or WIFI, you must configure your PC and your router..   See router configuration.

The cameras

Click on "Add camera". This opens the window configuration of the camera (except for the first camera that starts with the pilot by default). On this window select the "Source capture" then choose a camera and click "OK".

Repeat as many times as necessary, until you've memorized all the cameras.

If the camera image is blurred, we must click on "Format" module, then select "RGB 24" on the menu."

Caméra module

1: Image of the camera. Click above to display the monitor.

2: Seeing intrusion.

3: Name of the camera.  Click on it to change it.

4: Viewing the threshold of sensitivity.

5: Value of threshold of sensitivity.

6: Anti-interference filter.

7: Choice of the video source.

8: Choice of video format.

9: Close the camera track.

Renaming cameras:

Simply enter the new name instead of "camera 1,2,3 etc. (See 3) on each cameras track.

Reverse order of tracks:

With the mouse, move the tracks.

Display monitors:

Click on the image of the camera (See 1). This opens the monitor of the track.

The anti-interference filters: (See 6)

The camera image is not perfect, many pixels change color and distort the analysis.

To remedy this problem, these pixels are discriminated in the following manner:

 -Anti-interference 1:  The pixels which are isolated, are ignored.

 -Anti-interference 2:  The pixels that are not on 2 consecutive images are ignored.

 -Persistant intrusion: A zone that is detected, could trigger the alarm only if it persists over several images.